Configuring The Partner Printer; Using The Smart Relay Telnet Commands - Paxar 9860 Operating Instructions Manual

C o n f i g u r i n g t h e P a r t n e r P r i n t e r
The partner printer must be configured to 115200 Baud, No parity,
8-bit word length, 1 stop bit, and XON/XOFF flow control.
Select Setup, Port Settings, Serial Comm from the partner
1.
printer's Main Menu. If password protection in enabled, press
Feed/Cut three times, then press Enter/Pause before you see the
Setup Menu options.
2. Select Baud Rate and press
115200. Press Enter/Pause.
Press or
3.
Press Enter/Pause.
Press or
4.
Press Enter/Pause.
5. Press or
Press Enter/Pause.
6. Press or
XOFF. Press Enter/Pause.
U s i n g t h e S m a r t R e l a y T e l n e t C o m m a n d s
See the following list of commands to configure the printers.
SET PRN RELay PORt [None/S2]
Sets the Smart Relay Partner Identification (port) number to None (no
partner printer) or S2 (partner printer connected to serial port 2). The
default is None.
to select Word Length. Scroll until you see 8.
to select Stop Bits. Scroll until you see 1.
to select Parity. Scroll until you see None.
to select Flow Control. Scroll until you see XON-
or to scroll until you see
Using the Smart Relay System 5-5