" Voice Mail Service
Setting the Voice Mail Tone
If your voice mail service sends a voice mail tone after a new message
has finished recording, set to "ON". "
message was recorded in your mailbox. You will hear a series of voice
mail tones then a dial tone after lifting the handset or pressing
(SP-PHONE/HEADSET)
Set to "OFF" when:
—you do not subscribe to a voice mail service.
—your voice mail service does not send a voice mail tone, or
—the unit is connected to a PBX.
Your phone comes from the factory set to "ON".
Make sure that the handset is on the cradle, the AC adaptor is
connected and the SP-PHONE/HEADSET indicator light is off.
(FUNCTION/EXIT)
1
Press
(_)
2
Press
"VOICE MAIL TONE?" is displayed.
(fl)
3
Press
(_)
4
Press
line, "LINE1" or "LINE2".
(fl)
5
Press
(_)
6
Press
mode.
(fl)
7
Press
≥A beep sounds and the setting is saved.
≥The display will return to step 2. To
program the other line, start from step 3.
To return to the standby mode, press
(FUNCTION/EXIT).
≥You can exit the programming mode any time by pressing (FUNCTION/EXIT).
36
. (Contact your service provider about your service.)
.
(^)
or
repeatedly until
OK/EDIT.
(^)
or
to select the desired
OK/EDIT (NEXT key).
(^)
or
to select the desired
OK/EDIT (SAVE key).
" icon will flash on the display if a
AM
11:50
SAVE AUTO# ?
11:50
AM
VOICE MAIL TONE?
11:50
AM
LINE 1
LINE1
AM
11:50
LINE 2
LINE2
AM
11:50
ON
11 / 24
11 / 24
11 / 24
1=NEXT
11 / 24
1=NEXT
11 / 24
1=SAVE