Eeprom Writing Mode - Panasonic MINAS A4P Series Instruction Manual

How to Use the Console
EEPROM Write Mode
EEPROM Writing
Operation at SELECTION display
Starting from the initial LED status,
press three time after pressing
then brings the display of

EEPROM Writing Mode,

Operation at EXECUTION display
Press to make
EXECUTION DISPLAY to
Keep pressing
until the display changes to
" " increases while
keep pressing
(for approx. 5sec) as
the right fig. shows.
Starts writing.
Finishes writing
• When you change the parameters which contents become valid after resetting,
displayed after finishing wiring. Turn off the control power once to reset.
Note 1) When writing error occurs, make writing again. If the writing error repeats many times,
this might be a failure.
Note 2) Don't turn off the power during EEPROM writing. Incorrect data might be written.
If this happens, set up all of parameters again, and re-write after checking the data.
Note 3) Between
driver main unit. If the connector is pulled out accidentally, insert the connector again and retry
from the beginning.
<Notice>
When you have set the parameters, write the parameters into EEPROM. If you turn the power supply
off before writing the parameters into EEPROM, those parameters are cleared.
96
,
when you execute writing.
Writing completes
To move to the next process, press
and , take care not to pull out a console connector from a servo
Writing error
.
will be