Conformity To Ec Directives And Ul Standards - Panasonic MINAS A4P Series Instruction Manual

Conformity to EC Directives and UL Standards

EC Directives
The EC Directives apply to all such electronic products as those having specific functions and have been
exported to EU and directly sold to general consumers. Those products are required to conform to the EU
unified standards and to furnish the CE marking on the products.
However, our AC servos meet the relevant EC Directives for Low Voltage Equipment so that the machine or
equipment comprising our AC servos can meet EC Directives.
EMC Directives
MINAS Servo System conforms to relevant standard under EMC Directives setting up certain model (condi-
tion) with certain locating distance and wiring of the servo motor and the driver. And actual working condition
often differs from this model condition especially in wiring and grounding. Therefore, in order for the machine
to conform to the EMC Directives, especially for noise emission and noise terminal voltage, it is necessary to
examine the machine incorporating our servos.
Conformed Standards
Subject
IEC60034-1 IEC60034-5 UL1004 CSA22.2 No.100
Motor
EN50178
EN55011
EN61000-6-2
Motor/
Motor IEC61000-4-2
IEC61000-4-3
and
IEC61000-4-4
driver
IEC61000-4-5
IEC61000-4-6
IEC61000-4-11
IEC : International Electrotechnical Commission
EN : Europaischen Normen
EMC : Electromagnetic Compatibility
UL : Underwriters Laboratories
CSA : Canadian Standards Association
<Precautions in using options>
Use options correctly after reading operation manuals of the options to better understand the precautions.
Take care not to apply excessive stress to each optional part.
Composition of Peripheral Equipments
Installation Environment
Use the servo driver in the envi-
ronment of Pollution Degree 1 or
2 prescribed in IEC-60664-1 (e.g.
Install the driver in control panel
with IP54 protection structure.)
176
Conformed Standard
UL508C
Radio Disturbance Characteristics of Industrial, Scientific
and Medical (ISM) Radio-Frequency Equipment
Immunity for Industrial Environments
Electrostatic Discharge Immunity Test
Radio Frequency Electromagnetic Field Immunity Test
Electric High-Speed Transition Phenomenon/Burst Immunity Test
Lightening Surge Immunity Test
High Frequency Conduction Immunity Test
Instantaneous Outage Immunity Test
Power
supply
Circuit
breaker
Control box
Insulated power supply
for interface
Noise filters for
signal lines
Ground-fault
Noise filter
breaker (RCD)
Surge
absorber
Protective earth (PE)
Conforms to Low-
Voltage Directives
Standards
referenced by
EMC Directives
Controller
CN X5
Driver
Noise filters
for
CN X1
signal lines
L1
L2
CN X2
L3
U
V
W
L1C
L2C
CN X6
Motor
M
RE