Tunturi Cardio Fit M50 User Manual page 10

GB
- Make sure that only one person uses the equipment at a time.
- The equipment must not be used by persons weighing more than
100 kg (220 lbs).
- Do not open equipment without consulting your dealer.
Electrical safety
- Before use, always check that the mains voltage is the same as the
voltage on the rating plate of the equipment.
- Do not use an extension cable�
- Keep the mains cable away from heat, oil and sharp edges.
- Do not alter or modify the mains cable or the mains plug.
- Do not use the equipment if the mains cable or the mains plug
is damaged or defective. If the mains cable or the mains plug is
damaged or defective, contact your dealer.
- Always fully unwind the mains cable�
- Do not run the mains cable underneath the equipment. Do not run
the mains cable underneath a carpet. Do not place any objects on
the mains cable�
- Make sure that the mains cable does not hang over the edge of a
table�
- Make sure that the mains cable cannot be caught accidentally or
tripped over�
- Do not leave the equipment unattended when the mains plug is
inserted into the wall socket�
- Do not pull the mains cable to remove the mains plug from the wall
socket�
- Remove the mains plug from the wall socket when the equipment
is not in use, before assembly or disassembly and before cleaning
and maintenance�
⚠ WARNING
• Never use water or any other liquid directly on or near the
equipment, but only via a damp cloth if moist is required to
clean the machine�
• Using liquid directly is harmful for the equipment's components,
and may result in an electric shock caused by a short cut circuit�
This could result in serious personal injury or even death.
Assembly instructions
Description illustration A
The illustration shows what the trainer will looks like after the
assembly is completed�
You can use this as a reference during your assembly, but do follow
the assembly steps always in the correct sequence as showed in the
illustrations�
Description illustration B
The illustration shows what components and parts you should find
when un-boxing your product.
‼ NOTE
• Small parts can be hidden/ packed in hollow spaces in the
Styrofoam product protection
• If a part is missing, contact your dealer.
Description illustration D
The illustrations shows you in the correct following order how to
assembly your trainer best�
‼ NOTE
• Part numbers shown in the assembly steps are commencing with
the spare part drawing that can be found in the online version
user manual�
⚠ WARNING
• Assemble the equipment in the given order.
• Carry and move the equipment with at least two persons.
⚠ CAUTION
• Place the equipment on a firm, level surface.
• Place the equipment on a protective base to prevent damage to
the floor surface�
• Allow at least 100 cm of clearance around the equipment.
• Refer to the illustrations for the correct assembly of the
equipment.
Additional assembly information
D2 How to fit the pedals correctly�
NOTE
• Right and left side are determined from an exercising positions
perspective�
Right hand pedal
Find the "R" or "L" mark on the pedal axle
- Fit the right hand pedal "R" into the right hand crank.
- Firstly turn the pedal axle in clockwise direction by hand�
- Use the wrench to fully tighten the pedal.
Left hand pedal
- Fit the left hand pedal "L" into the left hand crank�
- Firstly turn the pedal axle in counter-clockwise direction by hand�
- Use the wrench to fully tighten the pedal.
‼ NOTE
• Save the tools provided with this product, after you completed
the product assembly,
for future service purposes�
Use
Take out controller
The equipment controller can be taken from the stowage and held in
your hands during workout to make workout changes during workout
for your convenience�
- Lift out with your finger tip at the bottom of the controller.
- Gently pull out the controller staying connected with a curled
telephone wire with the equipment. ( ± 1.2 mtr cable length).
- Controller can be held in hands and used for workout adjustments
during workout.
⚠ WARNING
• Avoid the curled telephone wire can be caught by the moving
parts of the equipment during workout.
1 0