Life Fitness CLUB Series Assembly Instructions Manual page 11

FIGURE 10
1
CABLE
9
STEP 10:
• SECURELY assemble the GUIDE ROD SUPPORT (8) to the TOWER (1) using four RH CAPS (36), two 3/8 X 2-1/2" BOLTS
(13), four 3/8" RH WASHERS (20) and two 3/8" LOW HEIGHT LOCK NUTS (18) as shown in FIGURE 10.
• Slide GUIDE ROD BUSHINGS (29) into the tubes on the GUIDE ROD SUPPORT (8), slide 1" SHAFT COLLARS (28) under-
neath the GUIDE ROD BUSHINGS (29) and SECURELY tighten the set screws.
• Insert the WEIGHT STACK PIN (23) into the WEIGHT STACK as shown in FIGURE 10.
• Screw the threaded end of the CABLE ALL THE WAY into the end of the shaft on the HEAD PLATE (9) and tighten jam nut
securely. See FIGURE 10.
18
8
29
28 TIGHTEN!
23
11
20
13 3/8 X 2-1/2"
36