Fujitsu ASUH30LPAS Design & Technical Manual page 52

STEP 2: Selecting the function number and setting value
1. Press the TEMP./SELECT (
number. To switch between the left and right digits, press the
MODE button.
2. Press the FAN SPEED button to proceed the setting value. To re-
turn the function number selection, press the FAN SPEED button
again.
3. Press the TEMP./SELECT (
value. To switch between the left and right digits, press the MODE
button.
4. Press the TIMER button, and when the indoor unit beeps, press
the (START/STOP) button to confirm the settings.
/
5. Press the RESET button to cancel the function setting mode.
6. After completing the function setting, be sure to disconnect the
power supply and then reconnect it.
CAUTION
• After disconnecting the power supply, wait 30 seconds or more before reconnecting it. The func-
tion setting will not become active unless the power supply is disconnected and then reconnect-
ed.
• When using a custom code other than , press RESET and then press and hold MODE again
for 5 seconds or more to set the custom code.
11-1. Function settings by using remote controller
) ( ) buttons to select the function
) ( ) buttons to select the setting
- 48 -
Function number
Setting value
11. Function settings