Fujitsu ASUH30LPAS Design & Technical Manual page 31

¢ External heater output
Control
Auxiliary heater
control 1
Auxiliary heater
control 2
Heat pump prohibition
control
Auxiliary heater
control by outdoor
temperature 1
Auxiliary heater
control by outdoor
temperature 2
Auxiliary heater
control by outdoor
temperature 3
Auxiliary heat pump
control
Auxiliary heat pump
control by outdoor
temperature 1
Auxiliary heat pump
control by outdoor
temperature 2
Auxiliary heat pump
control by outdoor
temperature 3
NOTES:
• After turning off the heater, 3 minutes of standby time is required by next power-on of the
heater.
• For items marked "—" in the table, any of validate or invalidate of the setting are acceptable.
• *1: External device means Hot water, Electrical heater, etc.
• *2: Sensor activation:
– Setting change from the factory setting is required.
– Indoor unit fan setting will be on for safety reason without sensor activation of wired remote
controller.
 Installation configuration of individual connection
External heating device is installed individually. (No use of indoor unit fan)
8-4. Details of function
Primary heater Auxiliary heater
Heat pump
External device*
Heat pump External device
External device
Heat pump External device
Heat Pump External device
Heat Pump External device
External device Heat pump
External device Heat pump
External device Heat pump
External device Heat pump
Example of heating device:
- Floor heating device
Indoor unit
Control switching
external heaters
No. 61
1 61-00
61-01
None 61-02
61-03
61-04
61-05
61-06
61-07
61-08
61-09
ON / OFF
- 27 -
Function setting
Wired R. C.
Sensor activation*
—
—
On (Enabled)
On (Enabled)
On (Enabled)
On (Enabled)
On (Enabled)
On (Enabled)
On (Enabled)
On (Enabled)
8. External input and output
2