Repair; Battery Pack Replacement - Graco LineDriver ES 25U670 Operation - Repair - Parts

Repair

Battery Pack Replacement

NOTE: Prior to replacing batteries, refer
toTroubleshooting - LineDriver, page 22, to
determine if the batteries are the cause of the problem.
Never mix battery types or brands. A new battery can
be mixed with older batteries. The LineDriver ES ships
with three lithium batteries, however, a fourth battery
can be added for additional run time between charge.
1. Turn Power Switch OFF. Turn lights OFF.
Disconnect 12V accessories. Unplug the battery
charging cord.
2. Remove Tool Tray.
3. Remove rear screws of Seat Lid.
4. Pivot Operator Seat forward slowly.
3A9034B
5. Remove battery cables. Always disconnect
negative (black) cables prior to disconnecting
positive (red) cables.
6. Remove batteries and recycle according to below.
7. Install new batteries. Install cables positive to
positive and negative to negative. To prevent
battery terminal short circuit, always connect the
positive (red) cables prior to connecting negative
(black) cables.
8. Reinstall seat and Tool Tray.
9. Charge batteries. See Charging the Batteries, page
12.
Repair
19