General Repair Information - Graco LineLazer IV 200HS Repair And Parts Manual

General Repair Information

General Repair Information
1. Keep all screws, nuts, washers, gaskets, and
electrical fittings removed during repair proce-
dures. These parts are not normally provided with
replacement assemblies.
2. Test repair after problem is corrected.
3. If sprayer does not operate properly, review
repair procedure to verify procedure was done cor-
rectly. If necessary, see Troubleshooting, page 8,
for other possible solutions.
4. Install belt guard before operation of sprayer and
replace if damaged. Belt guard reduces risk of
pinching and loss of fingers.
Grounding
Ground sprayer with grounding clamp to earth ground
when flushing sprayer. F
6
. 1.
IG
grounding
F . 1
IG
SAE O-Ring Installation
1. Unscrew lock nut to touch
fitting.
2. Lubricate o-ring (A).
3. Screw in fitting hand tight.
4. Unscrew fitting until
oriented properly.
5. Tighten lock nut to
clamp
water pipe, steel
sign post, or
metal light pole
TI06250
A
A
ti5414a
TI5415a
TI5416a
TI5417a
312226P