Programming Via Direct Commands - Panasonic KX-TG2388 Operating Instructions Manual

Programmable Settings
Main menu
Initial setting

Programming via direct commands

You can also program features using "direct commands"-special codes that take you
directly to the feature you wish to program and allow you to select the desired setting.
There is no need to scroll through the unit's menus.
Details of each feature can be found on the corresponding pages.
Important:
L Before programming, make sure the handset and base unit are not being used. The
handset must be operated near the base unit and while off the base unit or charger.
1
Press {MENU}.
2
Enter the desired feature code (page 37).
3
Enter the desired setting code (page 37).
L This step may vary depending on the feature being programmed.
4
Press {Save}.
5
Press {OFF} to exit programming mode.
Note:
L If you make a mistake or enter the wrong code, press {OFF} then start again by
pressing {MENU}.
36
For assistance, please visit http://www.panasonic.com/consumersupport
Sub-menu 1
Set answering
Message alert
LCD contrast
Key tone
Auto talk
Caller ID edit
Set tel line
Set base unit
Change language
Sub-menu 2
Number of rings
Recording time
Remote code
Recording mode
-
-
-
-
-
Set dial mode
Set flash time
Set line mode
Ringer tone
Incoming call.
Talk Caller ID
-
Page
54
54
54
55
55
41
42
43
42
15
43
43
40
40
41
14