Table of Contents
Advertisement
Key Tone
You can select whether or not the handset keys will sound tones (key tone,
confirmation tone, error tone). The factory preset is ON.
Press [MENU].
1
Scroll to "Initial setting" by pressing [
2
or [
], then press Select.
B
Scroll to "Key tone" by pressing [
3
then press Select.
Select "Off" or "On" by pressing [
4
Press Save, then press [OFF].
5
Re-registering the Handset
If "No link to base. Move closer to base, try again." is displayed
even when using the handset near the base unit, the handset may have lost
communication with the base unit. You need to re-register the handset to the base
unit.
• Make sure the base unit is not being used.
• Have both the handset and base unit nearby during registration.
• Follow steps 1 and 2 listed below. You have about 1 minute to complete
them.
Base unit:
1
Press and hold [LOCATOR/INTERCOM] until a beep sounds.
• The CHARGE indicator flashes.
Handset:
2
Press and hold [FLASH/CALL WAIT] until
Handset Registering
"
• When registration is complete, a beep sounds
from the handset.
• Wait for 20 seconds after registration is
complete while the handset establishes
communication with the base unit.
• If the handset beeps 3 times and "Error!!" is displayed, an error occurred. Try
again from step 1.
• You can stop registration by pressing [OFF] on the handset, and pressing
[LOCATOR/INTERCOM] on the base unit.
For assistance, please call: 1-800-211-PANA(7262)
Handset
is displayed.
"
Special Features
]
Initial setting
d
K
] or [
],
Key tone
B
d
K
] or [
].
B
d
Key tone
:On
K
Handset & Base Unit
Handset
Handset [1]
Back
Select
dB
Back
Select
dB
Back
Save
dB
Registering
Registered
L
L
L
51
Advertisement
Table of Contents
