Interrupting A Copy Run; Interrupt Copying - Olivetti d-Copia 16W Operation Manual

INTERRUPTING A COPY RUN

A copy run can be temporarily interrupted to allow another copy job to be performed. When the other job is finished,
the copy run will resume using the original copy settings.
Note
Interrupt copying is not possible when the user programs are being configured.
1
Press the [INTERRUPT] key (
interrupt the copy run.
INTERRUPT
• If the SPF is being used, the copy run will
Note
not stop until the set number of copies is
completed.
• If "Auditing mode" is enabled:
"- - -" will appear in the number of copies
display. Enter your 3-digit account number.
Copying will not be possible unless a
correct account number is entered. (p.39)
2
Remove the previous original(s) and
place the original(s) of the interrupt
copy job.
3
Set the number of copies and other
copy settings and then press the
[START] key (
28
) to
The INTERRUPT
indicator will light up and
the machine will revert to
the initial settings. (p.12)
The INTERRUPT
indicator will blink until
the current copy run
stops.
).

(Interrupt copying)

4
When the copy job is finished, press
the [INTERRUPT] key (
the original(s).
The INTERRUPT indicator will go off, indicating
that the interrupt function is no longer operating.
The copy settings will automatically revert to the
settings selected for the copy run before the run
was interrupted.
5
Replace the previous original(s) and
press the [START] key (
The interrupted copy run will resume.
) and remove
).