Hilti NURON TE 2-22 Original Operating Instructions page 20

5.7 Removing the accessory tool
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or
have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
1. Pull the accessory tool retaining bar back as far as it will go.
2. Remove the accessory tool.
5.8 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether
for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining
strap and the Hilti tool tether #2261970.
▶ Secure the retaining strap to the installation openings for accessories.
Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure
the second carabiner to a load-bearing structure. Check that both
carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap
and those of the Hilti tool tether.
6 Operation
Observe the safety instructions and warnings in this documentation and on
the product.
6.1 Switching on and off
1. To switch the product on, press the control switch.
2. To switch the product off, release the control switch.
6.2 Direction of rotation
▶ Set the direction of rotation.
▶ The selector switch engages in this position.
14 English
5
6
2343729
*2343729*