Registering The Dr Detector To An Nx Workstation Using Automatic Registration - AGFA DR 10s User Manual

90 | DR 10s | Advanced Operating
Registering the DR Detector to an NX Workstation using
automatic registration
1. Start the NX workstation.
2. Turn on the detector.
During startup the status indicator is flashing orange. After startup the
status indicator is lit green, indicating the power status.
3. Hold the detector with its IR data port close to the IR Data Communication
Unit that is connected to the NX workstation.
A dialog is displayed on the NX workstation indicating that the network
settings of the DR Detector are being updated.
After a short time another dialog is displayed indicating that sharing the
DR Detector has been successful. It may take up to 30 seconds for the
dialog to pop up.
The DR Detector is restarting.
4. Remove the detector from the IR Data Communication Unit and click OK.
5. In specific configurations, the DR Detector turns to error status directly
after registration to another NX workstation, or after attempting a first
exposure. In this case, stop and restart the DR Detector using the power
button, each time after it has been registered to another NX workstation.
For more information, contact your local service representative.
The DR Detector is set up to make connection to the selected NX workstation.
The DR Detector connection status icon in the DR Detector Switch is
displayed.
Related Links
Stopping the DR Detector
Starting the DR Detector
0351A EN 20190319 1349 *
Note: Do not cover the IR data port of the DR Detector with
your hands. Otherwise, the properties of wireless
communication, such as the throughput and operable distance,
may decrease.
Note: Other detectors in the direct vicinity may interfere
with the communication to the NX workstation. Make sure
they are out of reach of the IR Data Communication Unit.
on page 78
on page 67