AGFA Crystal-M Imager Reference Manual page 77

10. Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
A screen summarizing the information you have entered will appear:
-Netmask:
255.255.252.0
-Netmask:
Router IP-address:
255.255.252.0
10.233. 92.1
Router IP-address:
Printer AE-title:
10.233. 92.1
Drystar5302
Printer AE-title:
--------------------
AEHARDCOPY
x Repeat step 1
--------------------
v Go to step 2
x Repeat step 1
v Go to step 2
11. Press the Confirm key to go to step 2 of the installation wizard or press the
Escape key to repeat step 1.
When you have pressed the Confirm key, the following screen will appear:
--------------------
Press x to exit
--------------------
the wizard. You can
Press x to exit
continue later via
the wizard. You can
Browser or keypad.
continue later via
Browser or keypad.
12. From here on, you can use the Web browser on the remote PC to continue
with the installation wizard. The data entries are the same, but the
browser is easier to 'manipulate' than the local keypad.
Press the Escape key to exit the wizard on the local keypad.
13. If you wish to continue with the installation wizard from the local keypad,
press the Confirm key to continue.
Related Links
Controlling the printer via a remote PC (with browser)
Data entry on page 12
Entering modality specific settings
An instruction screen shows the information you need to complete this part of
the installation:
name
-Modality brand
-Modality type
-Modality AE-title
--------------------
ask your network
administrator for
this information.
Crystal-M Imager | Advanced Operation (key-operator mode) | 77
Note: Entries are case sensitive.
on page 82
3853B EN 20210520 0952