AGFA Crystal-M Imager Reference Manual page 72

72 | Crystal-M Imager | Advanced Operation (key-operator mode)
5. Insert the USB flash drive.
6. If there are multiple dataset files present on the USB flash drive, a list is
shown.
The 'Select dataset' screen is displayed:
Dataset xyz v1.00
Dataset abc v1.00
Dataset def v1.00
etc...
7. Press the up/down arrow keys to select the desired save set file, followed
by the Confirm key.
The following confirmation screen is displayed:
8. Press the Confirm key (YES) to proceed with the selected file, or the
Escape key (NO) to quit the procedure without any changes.
The printer restores the configuration from the external USB flash drive:
When the copying of the save set is finished, the printer will ask you to
remove the USB flash drive:
9. Remove the USB flash drive.
As soon as the USB flash drive has been removed, the following screen is
displayed (when necessary):
10. Press the Confirm key to reset the printer or press the Escape key to reset
the printer later. After the reset, the new settings will be active.
Related Links
General save configuration procedure
3853B EN 20210520 0952
Note:
If no data available on the USB flash drive, the following
message is displayed:
on page 51