Corrosion Protection; Electrical Connection; Refill Coolant - Grizzly G0875 Owner's Manual

Check the correct alignment of the machine after a few days of use.

3.5

Corrosion Protection

A corrosion protection is applied on the machine table and on the guiding surfaces for trans-

port and storage. Remove the anti-corrosive agent from the CNC machine before first com-
missioning. We recommend you use paraffin for this purpose.
3.6

Electrical connection

CAUTION!
Lay the connection cable to the electrical cabinet and the cable of the coded connector
from the machine to the electrical cabinet in such a way as to prevent a trip hazard.
WARNING!
The three-phase electrical connection may only be performed by an electrician or under
the guidance and supervision of an electrician.
Please check that the type of current, voltage and protection fuse correspond to the values
specified. A protective earth ground wire connection must be available.
Min. terminal cross-section per phase and grounding: 2.5mm

Electric connected load: 4 KVA

Permissible voltage fluctuations in normal operation: +6% -10% Volt

Permissible frequency fluctuations: ± 1Hz (50/60 Hz)

Permissible phase imbalance: 3% or less

ATTENTION!
Ensure that all 3 phases (L1, L2, L3) and the ground wire are connected correctly.
The neutral conductor (N) of its power supply is not connected.
ATTENTION!
Check if the drive motor is turning in the correct rotation direction. If necessary, two
phase connections must be swapped.
In the event of an incorrect rotation direction, machine components may be damaged.
The guarantee will become null and void if the machine is connected incorrectly.
 Check the fusing (fuse) of your electrical supply according to the technical instructions
regarding the total connected power of the machine.
Firmly connect the machine.

Please check that the type of current, voltage and protection fuse correspond to the values
specified. A protective earth ground wire connection must be available.
Observe the notes on the connection for machines with frequency converters.
3.7

Refill coolant

The CNC machine is delivered without coolant.
Fill the coolant lubricant tank with an appropriate cooling lubricant via the filler hole.

 "Cooling lubricants" on page 242
-28-
2
Model G0875 (Mfd. Since 3/19)