Mitsubishi LT-2220 Owner's Manual page 19

Note: The TV side panel and connections shown here are for reference only and may vary by model.
See Appendix B, page 58 for component video
signal compatibility information.
For digital audio connections, see your DTV
receiver and A/V receiver Owner's Guides.
(Figure 11)
Connect the outside antenna cable, or satellite to
1.
ANT or SATELLITE IN on the DTV receiver
(see your DTV receiver owner's guide for
instructions and cable compatibility).
2. If your DTV receiver has a built-in terrestrial tuner,
connect the incoming terrestrial antenna to ANT
on the DTV receiver. If your DTV receiver does
not have a built-in terrestrial tuner, this TV will
only be able to provide an analog signal through
ANT on the TV side panel.
3. Connect the RCA-type cables from the DTV
receiver outputs to the TV side panel. Component
(1 or 2) may be used for 480i, 480p, 720p or 1080i
components.
4. Connect the L (left) and R (right) audio cables
from the DTV receiver to DTV AUDIO on the
TV back panel.
5. To utilize the benefits of a digital A/V receiver,
connect your DTV receiver's digital audio out to a
digital input on your digital A/V receiver.
Red
White
Incoming
Antenna,
or Cable.
2
DTV Receiver (with component video connections)
3
3
3
Figure 11. Connecting the DTV receiver with
component Video Connections.
TV Side Panel - right
4
4
3
3
3
2
White
4
4
Red
IN FROM ANT
SATELLITE IN
or
1
to antenna,
cable or satellite
19
1