Mitsubishi LT-2220 Owner's Manual page 18

Note: The TV side panel and connections shown here are for reference only and may vary by model.
2
Red
White
A
B
C
1
1
A
Y VIDEO
B
C
B
S
C
C
R
VIDE O OUT
Figure 9. Connecting a DVD Player with Component Video.
See Appendix B, page 58, for component video
signal compatibility information.
For digital audio connections, see your DVD
and A/V receiver Owner' s Guides.
TV side panel - left
2
Red
White
White
Red
2
Figure 10. Connecting an S-Video Device.
18
TV side panel - right
DVD back panel
AUDIO OUT
MITS UB IS HI AC IN
5.1 CH SURROUND 2CH BITSTREAM/PCM
DVD PLAYER
CENTER MODEL DD-5000
White
POWER SUPPLY 120V~ 60Hz
L
POWER CONSUMPTION 20W
SERIAL NO.
MANUF ACTURED
R DISTRIBUTED BY
MITSUBISHI DIGITAL ELECTRONICS Red
AMERICA, INC. 2
SUBWOOFER SURROUND FRONT COAXIAL OPTICAL 9351 JERONIMO ROAD
IRVINE, CA 92618
MADE IN JAP AN
1
Any S-Video Device
AUDIO OUT AUDIO IN VIDEO OUT
L L (Y/C)
1
2
1
R R
(Figure 9)
1. Connect the Component Video cables from
(Y Cb Cr or Y Pb Pr) VIDEO OUT on the back of
the DVD player to COMPONENT (1 or 2) on
the TV side panel. The correct connections are:
Y to Y
A.
Cb or Pb to Pb
B.
Cr or Pr to Pr
C.
Connect a set of audio cables from AUDIO OUT
2.
on the back of the DVD player to COMPONENT
AUDIO Input (1 or 2) on the TV side panel.
• The red cable connects to the R (right)channel
• The white cable connects to the L (left) channel
NOTE: Some video game systems support component
connections. Please refer to your video game
console Owner's Guide.
NOTE: If your DVD player supports progressive
scan playback, be sure to set your player
accordingly. Please refer to your DVD player's
Owner's Guide.
(Figure 10)
1. Connect an S-Video cable from VIDEO OUT
on the device back panel to VIDEO INPUT-1 or
INPUT-2 on the TV side panel.
2. Connect a set of audio cables from AUDIO OUT
on the device back panel to AUDIO INPUT-1 or
INPUT-2 on the TV side panel.
• The red cable connects to the R (right) channel
• The white cable connects to the L (left) channel
If your S-Video Device is mono (non-stereo), connect
only the white (left) cable.