Mitsubishi LT-2220 Owner's Manual page 16

Note: The TV side panel and connections shown here are for reference only and may vary by model.
TV side panel (section detail)
3
Cable Box Rear Terminals
2
VCR back panel
2
Antenna
3
Figure 5. Connecting the VCR with cable box.
TV side panel - left
Red
2
White
VCR back panel
IN
White
2 Antenna
Red
OUT
Figure 6. Connecting the VCR Audio/Video.
16
Incoming Cable
1
OUT IN
AUDIO IN
AUDIO OUT
IN
L L
1
1 2
MONITOR
R R
OUT
(Recommended if available)
Attach only
1
one cable type
If your VCR has a video
channel or RF ON/OFF
switch, set to OFF.
VIDEO OUT
AUDIO OUT AUDIO IN
L L (Y/C)
1
1 2
MONITOR
R
R
(Figure 5)
1. Connect the incoming cable to ANT on the TV
side panel.
NOTE: For best performance, please see Composite
Video with Audio or S-Video with Audio,
below.
VIDEO OUT
(Y/C)
(Figure 6)
1. Connect a video or an S-Video cable from VIDEO
OUT on the VCR back panel to VIDEO or
S-VIDEO, INPUT-1 or INPUT-2 on the TV side
panel.
2. Connect a set of audio cables from AUDIO OUT
on the VCR back panel to AUDIO INPUT-1 or
INPUT-2 on the TV side panel.
1
• The red cable connects to the R (right) channel
Attach • The white cable connects to the L (left) channel
only
one
cable
type
If your VCR is mono (non-stereo), connect only the
1
white (left) cable.
You may connect to the S-VIDEO or VIDEO
terminal but not to both.