Setting Module Speed Threshold (Passive Module Only); Configuring Trunks - 3Com CoreBuilder 5000 User Manual

Setting Module
Speed Threshold
(Passive Module
Only)
Example:

Configuring Trunks

Use the SET MODULE SPEED_THRESHOLD command to set the number
of times that a phantom transition caused by a ring speed mismatch is
allowed to cause a port to unwrap before the port is removed from the
ring. This command applies to the CoreBuilder 5000 Passive Token Ring
Media Module (Model Number 6220M-TP). Use the Set Port Speed
Detect command to enable speed detection. The default is 7.
The command sequence is:
SET MODULE {slot}.1 SPEED_THRESHOLD {threshold}
Where:
{slot}.1 = module 1 to 17, subslot 1
{threshold} = 0 to 255 phantom transitions
To reset this threshold, disable and re-enable the port from the
management console.
The following command sets the speed threshold of the module in slot
7 to a maximum of 7. If this threshold is exceeded for a port or trunk,
that port or trunk is removed from the ring:
CB5000> set module 7.1 speed_threshold 7 [ENTER]
Threshold set to 7.
The default Threshold is 7. A value of 0 (zero) means infinite, therefore
you will never reach maximum threshold value.
Use the SET TRUNK command to configure the following options for
either copper or fiber trunk ports:
Trunk Enable
Trunk Network Selection
Trunk Compatibility Mode
You must install a Jitter Attenuator Card on any module that connects
to a non-CoreBuilder 5000 network.
Configuring Trunks 4-11