Enabling Mismatch Resolution; Modules Only) - 3Com CoreBuilder 5000 User Manual

Enabling Mismatch
Resolution (Passive
and Active
Per-Module Media

Modules Only)

The command sequence is:
SET PORT {slot}.{port} STATIC_SWITCH {setting}
Where:
{slot} = hub slot 1 to 17
{port} = 1 to 24 or all
{setting} = disable
enable
The following command disables static switch on port 2 on the module
in slot 6:
CB5000> set port 6.2 static_switch disable
Port 6.02 set to DISABLED.
The default is enable, forcing the users to power off the station to
switch rings.
Use the SET NETWORK TOKEN_RING MISMATCH_RESOLUTION
command to:
Enable the mismatch resolution algorithm for the specified network.
Perform address-to-port mapping when you use a splitter or
fan-out device on a CoreBuilder 5000 Token Ring port.
The default is disable.
The command sequence is:
SET NETWORK TOKEN_RING {network} MISMATCH_RESOLUTION
{mode}
Where:
network = token_ring_1 - token_ring_10
isolated slot
isolated_1 slot - isolated _11 slot
mode = enable
disable
Configuring the Modules
[ENTER]
4-7