Setting Port Alert Filters; Corebuilder 5000 Token Ring Network Mode - 3Com CoreBuilder 5000 User Manual

Setting Port Alert
Filters
If you enter the command shown in the previous example, all ports
assigned to network isolated_3 join backplane network token_ring_3
(Figure 4-1).
Figure 4-1

CoreBuilder 5000 Token Ring Network Mode

Use the SET ALERT PORT ALERT_FILTER command to enable or disable
port up and port down trap generation for a specific port. This
command works in conjunction with the SET ALERT
(PORT_UP_DOWN_FILTER) command.
Once the SET PORT ALERT_FILTER command has been enabled for a
port, you must issue the SET ALERT PORT_UP_DOWN_FILTER command
to allow or prevent port up and port down traps to be transmitted
from the DMM to the designated trap receiver. The DMM sends a
port_up_down trap whenever a port on the stack starts operating (goes
up) or stops operating (goes down). If you disable the port_up_down
alerts, the DMM does not generate the alerts. If you enable the
port_up_down alerts, the DMM generates alerts for all ports in the
hub.
Configuring the Modules
AAAA AAAA AAAA AAAA AAAA AAA
AAAA AAAA AAAA AAAA AAAA AAA
AAAA AAAA AAAA AAAA AAAA AAA AA
AAAA AAAA AAAA AAAA AAAA AAA
AAAA AAAA AAAA AAAA AAAA AAA
4-9