Table of Contents
Advertisement
FLOW CHARTS
The following flow charts should be used to determine the source of a malfunction down to an assembly level.
Locate the flow chart which best describes the malfunction. If you are unsure about which flow chart to use,
begin with the "Power" flow chart which will direct you to the area of concern.
Insure that the power source has been removed from its case before performing the applicable procedure.
POTENTIAL SHOCK HAZARD The following Flow Chart procedures
are to be performed by qualified service personnel only. Line voltage
parts are exposed. Service personnel must avoid contact with these
parts when troubleshooting the power source.
WARNING
REPAIR
39
Advertisement
Table of Contents
