9. Do not defeat the safety purpose of the polarized or grounding- type plug. A polarized plug has two blades with one wider than To ensure correct operation, use this set-top box only with the Pace- the other. A grounding type plug has two blades and a third approved power supply unit provided.
Page 4
Data Record • You can place your set-top box near other consumer electronics devices, such as stereo amplifiers or televisions, but you must not place it directly on top or underneath them. XG1-P (PX001BNT and PX001BNM) USER GUIDE DRAFT (501-100190x)
SAFETY INFORMATION (cont.) Safety aspects of connections To ensure correct operation, use this set-top box only with the Pace-approved power supply unit provided. If you use an unapproved alternative, you will Full details of the rear panel are on page 6.
Connect to a TV with a 1394 port or to any other 1394-compatible device. +12V DC In Power Connect your set-top box’s power supply unit here. Make this connection last of all. CableCARD module Removal will interrupt your service. XG1-P (PX001BNT and PX001BNM) USER GUIDE DRAFT (501-100190x)
Please use the YPbPr component connection to watch TV. The HDMI output is then disabled, so no picture is transmitted from this connector. In that case, use the component video connectors to connect up (see Setup B). XG1-P (PX001BNT and PX001BNM) USER GUIDE DRAFT (501-100190x)
Use the HDMI path or an alternate direct video path from your set-top box to your TV. Remember to select the you live. correct input on your TV. XG1-P (PX001BNT and PX001BNM) USER GUIDE DRAFT (501-100190x)
Unplug your set-top box’s power supply unit from the wall AC outlet. Then plug this power supply unit in again at the wall AC outlet (and, if there is a switch by this outlet, switch it to its ON position). XG1-P (PX001BNT and PX001BNM) USER GUIDE DRAFT (501-100190x)
Consult the information supplied by your cable service-provider for details on how to make the most of the digital cable services. Also read the operating instructions that are supplied with your remote control. XG1-P (PX001BNT and PX001BNM) USER GUIDE DRAFT (501-100190x)
2. Pace reserves all rights not expressly granted to you under these Terms. 3. You may not transfer any of your limited rights in the Software without the prior written consent of Pace, and if consent is provided then the Software shall only be transferred in conjunction with the transfer of the Product AND ONLY IF the transferee has read and agreed to accept these Terms.
Page 13
These Terms are governed by the laws of the State of New York and you may only bring claims exclusively in New York courts and Pace shall be entitled to bring a claim in the courts of any jurisdiction. Any failure by Pace to enforce any of its rights hereunder or applicable law shall not constitute a waiver of such rights.
Page 14
Pace and are trademarks and/or registered trademarks of Pace plc. 501-100190x...