Table of Contents
Advertisement
Service work
As the measure against this symptom, the factory is using the new type compensation sheet [2] which is
made by dividing the (old type) compensation sheet [1] into 2 parts to change the attaching angle. This
prevents delivered paper from butting against the lower entrance guide of the Inner Finisher-C1.
When the old type compensation sheet was attached, follow the steps below.
[Caution] In the combination use of the Inner 2 way tray-F1 and the 3 way unit-C1, do not remove the old
type compensation sheet. A jam can occur.
1) Open the lower right door [3].
2) Open the 2nd/3rd delivery guide assembly so that the compensation sheet [1] will come in sight.
pg. 23
Hide quick links:
Advertisement
Table of Contents
