[Media Clamps Could Not Be Detected.]; [The Lan Cable Is Not Connected.]; [Connection Is Requiring Too Much Time. Manually Setting The Ip Address Will Improve The Connection Speed.] - Roland TrueVIS SG3-540 User Manual

Messages
Check the loading status of the media and that the pinch rollers have been positioned correctly, and then
correctly set the media clamps at the ends of the media.
RELATED LINKS
・ P. 30 Setup of New Media
・ P. 67 Setup of Registered Media

[Media clamps could not be detected.]

This message appears when the media clamps cannot be detected because they are hidden by the me-
dia.
Check the loading status of the media and that the pinch rollers have been positioned correctly, and then
correctly set the media clamps at the ends of the media.
This message appears when the media clamps cannot be detected because their parts that are read
are dirty with, for example, ink.
Use cleaning liquid and a cleaning stick to clean the white parts on the media clamps.
It may not be possible to detect the media clamps because the multi sensor is dirty with ink due to
reasons such as the media striking it immediately after printing.
Install the media clamps correctly and clean their parts that are read. If this message still appears, con-
tact your authorized Roland DG Corporation dealer.
RELATED LINKS
・ P. 30 Setup of New Media
・ P. 67 Setup of Registered Media

[The LAN cable is not connected.]

This message appears when the machine and a computer are not connected with a LAN cable.
Properly connect the LAN cable.
[Connection is requiring too much time. Manually setting the IP address will
improve the connection speed.]
This message appears when automatic IP address acquisition is enabled and the machine connects to a
network on which no DHCP server exists while this automatic acquisition is in progress.
Connect to a network on which a DHCP server exists or disable automatic IP address acquisition and set a
fixed IP address.
304
Messages on the Operation Panel