Installation; Preparation - Fluke VIBGUARD compact Manual

5 Installation

In this section you will learn how to mount the system and how to establish the electrical connections. Information
about installing the sensors on site can be found in the instructions for the respective sensors. For PRUFTECHNIK
sensors these are:
Installation instructions for IEPE-type sensors VIB 9.833

5.1 Preparation

For proper installation you, as the operator, must ensure that the following conditions are met and that the fol-
lowing preparations are made on site:
Ambient conditions
Temperature
Rel. humidity
Altitude
Installation site
EMC
Connections
Power supply
Network
Connecting cables, general requirements
Temperature range
Flammability
Shielded cable
VIBGUARD compact
-20°C to +60°C [-4°F ... +140°F] (system in protective housing)
-20°C to +70°C [-4°F ... +158°F] (system without protective housing)
max. 95% (25 °C [77°F ], no condensation)
max. 2000 m [6562 ft.]
Indoor installation (no direct sunlight)
There must be no strong electromagnetic fields in the immediate vicinity of the sys-
tem, e.g. in the vicinity of a generator or a high voltage cable.
100 - 240 V AC / 1.3 A / 50 to 60 Hz
Ethernet TCP/IP / 100 Mbit
-20°C to +80°C [-4°F ... +176°F]
flame retardant according to UL 2556 VW-1 or equivalent (IEC 60332-1-2 / IEC
60332-2-2)
shielding > 85%
Installation and Operation
21