Extra Weight - Stihl MM 56 Instruction Manual

9 Extra weight

NOTICE
Do not pull out the starter rope all the way – it
might otherwise break.
► Do not let the starter grip snap back. Guide it
slowly back into the housing so that the starter
rope can rewind properly.
► Continue cranking until the engine runs.
8.2.4 As soon as the engine runs
► Press down the throttle trigger lockout and
open the throttle – the choke knob moves to
the run position F. After a cold start, warm up
the engine by opening the throttle several
times.
WARNING
Make sure the carburetor is correctly adjusted.
The MultiTool must not rotate when the engine is
idling.
Your machine is now ready for operation.
8.3 Stopping the Engine
► Depress the momentary contact stop switch –
the engine stops – release the stop switch – it
springs back to the run position.
8.4 Other Hints on Starting
Engine stalls in cold start position g or under
acceleration.
► Move the choke knob to < and continue
cranking until the engine runs.
Engine does not start in warm start position <
► Move the choke knob to g and continue
cranking until the engine runs.
If the engine does not start
► Check that all settings are correct.
► Check that there is fuel in the tank and refuel if
necessary.
0458-489-0121-C
► Check that the spark plug boot is properly con‐
nected.
► Repeat the starting procedure.
Engine is flooded
► Move the choke knob to F and continue crank‐
ing until the engine runs.
Fuel tank run until completely dry
► After refueling, depress the manual fuel pump
bulb at least five times – even if the bulb is
already filled with fuel.
► Set the choke knob to suit the engine temper‐
ature.
► Now start the engine.
9 Extra weight
An extra weight (special accessory) may be ret‐
rofitted on the MultiEngine to increase the weight
on the MultiTool.
Use only original STIHL weights. The use of
other weights parts may result in damage to the
machine or personal injury.
9.1 Mounting the extra weight
MultiEngine without wheels
Use the combination wrench to unscrew and
retighten the weights.
Unscrew weights on the side without square end
– as follows:
1 2
The weights (1) on the side with the square
end (2) remain on the bolt.
► Take out the hex head screw (3) and remove
the outer weight (4).
► Loosen the inner weight (5) and remove it
from the bolt.
English
5 3
4
11