Extra Weight - Stihl MM 55 Instruction Manual

English
The machine is now ready for use.
If the carburetor has been set correctly,
the working tool should not rotate when
the engine is idling!
Switching off the engine
Push the slide control in the
N
direction of the arrow (h) to STOP-0
If the engine does not start
Choke lever
If the choke lever was not returned to e
in time after the engine turned over for
the first time, then the engine has
flooded.
Set choke lever to e
N
Move the throttle trigger, slide
N
control and throttle trigger lockout to
the starting throttle position
Start the engine – to do this, pull
N
starter rope briskly – 10 or 20 pulls
may be needed
If the engine still does not start
Move the slide control to STOP-0
N
Remove the spark plug – see
N
"Spark plug"
Dry spark plug
N
Crank the engine several times with
N
the starter – to clear the combustion
chamber
Replace the spark plug – see "Spark
N
plug"
14
Move the slide control to F
N
Set the choke lever to e – even if
N
the engine is cold
Restart the engine
N
Fuel tank run until dry
After refueling, press the fuel pump
N
bulb at least five times – even if it is
full of fuel.
Set the choke lever in accordance
N
with the engine temperature
Restart the engine
N

Extra weight

To increase the weight on the MultiTool,
the MultiEngine can be retrofitted with
an additional weight (special
accessory).
Always use original STIHL additional
weight. Using other weights can lead to
damage to the machine and personal
injuries.
Attaching additional weight
No wheels are attached to the
MultiEngine
Use the combination wrench to loosen
and tighten the weights.
Detach the weights on the side without
the square – to do this:
1 2 5
The weights (1) on the side with the
square (2) remain mounted on the bolt.
Unscrew the hexagon head bolt (3)
N
and remove the outer weight (4)
Detach the inner weight (5) and
N
remove it from the bolt
MM 55, MM 55 C
4 3