Extra Weight - Stihl MM 56 Instruction Manual

English
Fuel tank run until completely dry
After refueling, depress the manual
N
fuel pump bulb at least 5 times –
even if the bulb is already filled with
fuel.
Set the choke knob to suit the
N
engine temperature.
Now start the engine.
N
12

Extra weight

An extra weight (special accessory) may
be retrofitted on the MultiEngine to
increase the weight on the MultiTool.
Use only original STIHL weights. The
use of other weights parts may result in
damage to the machine or personal
injury.
Mounting the extra weight
MultiEngine without wheels
Use the combination wrench to unscrew
and retighten the weights.
Unscrew weights on the side without
square end – as follows:
1 2 5
The weights (1) on the side with the
square end (2) remain on the bolt.
Take out the hex head screw (3)
N
and remove the outer weight (4).
Loosen the inner weight (5) and
N
remove it from the bolt.
1 2
Push the extra weight (1) with bolt
N
through the bore (6) in the flange,
turning it until the square end (2)
engages the recess in the flange.
Screw the inner weight (5) onto the
N
bolt and tighten it down firmly.
Screw the outer weight (4) with the
N
hex head screw (3) into the thread
of the inner weight and tighten it
down firmly.
One of two weights may be mounted on
each side of the extra weight as
required.
Weight on each
side
1
4 3
2
NOTICE
The maximum allowable extra weight is
4 kg. Never use a heavier extra weight
as this may damage the machine.
MultiEngine with wheels
If the MultiEngine is already equipped
with wheels (special accessory), see
chapter on "Wheels", additional parts
are required to mount the extra weights.
In such a case have the extra weight
mounted by your servicing dealer.
4 3
6 5
Total extra weight
2 kg
4 kg
MM 56 C