Table of Contents
Advertisement
BATTERY PACK
Charging/ Operating time
When the battery pack is fully charged, the approximate
available operating time (the camcorder in recording
mode}, at normal temperatures, is as described below.
· : _ · , : : im R- : B r: : +n : : a ifii 6. t : : : : : : : : . : : � : : I : Q. ifif.t i i, :
: :
: : :
:
:
:
'i l ! I t:: : ijij@jl
:
:
:
:
:
:
:
:
: r : : : : r t: : • M mi : : : : : r : : : : : : : : JIIF• i timitJ: : : ? i t t : > : : : : • : t !m.ttrn• • • t >• : :
:
NP-55
210 m i n .
(supplied)
NP-77
(sold
420 m i n .
separately)
NP-77H
(sold
480 m i n .
separately)
Ni-MH battery pack
This AC adaptor/charger can also be used to charge
Ni-MH battery packs (model N P- S 8 8A, sold separately).
For more details, please consult the dealer where the unit
was purchased.
�Notes:
•The following operations also re quire power, and will
shorten the operating time indicated above. It is
therefore recommended to have available charged
battery packs to last 2 or 3 times the actual planned
recording duration.
•
Recording pause mode
•
Using the power zoom
•
Loading and unloading the cassette
•
Using a video light (sold separately)
•
Monitoring the recording on the remote control
colour monitor
•When the battery pack is used for the first time, the
operating time will be slightly shorter than normal. It
should be used until completely discharged and
recharged two or three times before the complete
charge is available.
•Charging the battery pack is possible within a
temperature range of 5° - 35°C. For best results, a
temperature range of 10° - 30°C is recommended.
e
If the camcorder is not used for a long period,
remove the battery pack. If not, the battery pack will
slowly loose its charge.
• Do not store a battery pack where it could reach
high temperatures.
•Battery packs last shorter when used in low
temperatures.
60 m i n .
65 m i n .
120 m i n .
130 m i n .
150 m i n .
140 m i n .
Installing the battery pack
The supplied battery pack has not been charged,
make sure to charge It before using It on the
camcorder for the first time.
POWER
1
Set the
switch to
2
Align the marks on the battery pack with the ones on
the camcorder and while pressing it down, slide it in
the direction of the arrow, until a click is heard.
Removing the battery pack
To remove the battery pack, push and hold down the
BATT
button, then slide the battery pack in the opposite
direction of the arrow.
8
"OFF".
Advertisement
Table of Contents
