Table of Contents
Advertisement
BATTERY PACK
Installing the battery pack on the AC adaptor/
charger
1 Align the marks on the battery pack with the ones on
the AC adaptor/charger and while pressing it down,
slide it in the direction of the arrow until a click is heard.
2 Plug the AC adaptor/charger power cord into an AC
outlet. The POWER indicator (A) lights.
2 -
Recharging the battery pack
When the battery pack is installed on the AC adaptor/
charger and the power cord is plugged in an AC outlet,
the CHARGE indicator (B) will light and the battery pack
is automatically recharged. When it is fully charged, the
indicator will go off. Remove the battery pack in the
reverse order of installation.
Refreshing the battery pack
Install the battery pack on the AC adaptor/charger, then
press the REFRESH button (C). The CHARGE indicator
(B) will flash (slow cycle), and the remaining charge of the
battery pack is discharged, then the CHARGE indicator
will stop flashing and the battery pack is automatically
recharged.
�Notes:
e
If the CHARGE indicator flashes rapidly, remove the
battery pack immediately, then try again making
sure the battery pack is correctly installed. If the
CHARGE indicator still flashes rapidly it may
indicate that the battery pack cannot be used.
Please consult your dealer for assistance.
e
When finished, make sure to unplug the AC
adaptor/charger power cord from the AC outlet.
e
Do not use the AC adaptor/charger for a purpose
other than charging the battery pack or supplying
power to the camcorder.
Charge condition indicator switch
When the battery pack is fully charged, slide the switch
on the end of the battery in order to reveal the red circle.
Once it is exhausted, slide the switch to cover the red
circle.
This switch is used as a reminder only, it has no function
in the operation of the battery pack.
Battery pack low power indicator
The low power indicator
the remaining charge of the battery pack is low and there
are only a few minutes of operation left before the power
to the camcorder is cut off. The battery pack should be
recharged, or replaced with a charged one.
�Notes:
e
Do not short-circuit the battery pack terminals, and
never try to disassemble or modify it.
e
Do not throw in the fire, as it may explode.
e
Before recharging the battery pack, exhaust the
available charge or use the Refresh function of the
AC adaptor/charger. Recharging a battery pack
when it is not completely discharged will shorten the
operating time it provides.
e
If a charged battery pack is not used for
months or more, its charge will last shorter than
normal. To restore the charge to its original level, it
should be used until completely discharged and
recharged two or three times.
7
i!SJ
flashes in the viewfinder when
-
2
3
Advertisement
Table of Contents
