Table of Contents
Advertisement
PROGRAMMED EDITING USING THE REMOTE CONTROL
Programmed editing
Place the remote control directed toward the remote
control sensor on the VC R and leave it undisturbed until
the programmed editing is finished. (Make sure not to
place anything between the remote control and the VC R.)
1
Load a blank tape into the VC R, then set it to recording
pause mode.
2
Press the
RUN
button on the remote control. The
editing will start automatically.
The tape in the camcorder is rewound, and segments
A, C and B will be searched then played back in the
selected order.
Recorded tape (camcorder)
[No. 1]
Tape recorded using the programmed editing function
(VCR)
[No. 1]
[No. 2]
•The VC R will switch between recording and recording
pause mode to match playback on the camcorder.
e
If the
DATA ON SCREEN
on-screen display will appear while a segment is
searched, however it will disappear while the segment
is being copied.
3
When programmed editing is finished, the camcorder
is switched to stop mode, and the VC R to recording
pause mode.
•You can then, erase the programmed editing settings
and programme another 5 segments to be edited to the
same tape in the VC R, or load another blank tape in the
VC R and simply press the
same 5 segments.
�Notes:
•After editing, the settings are not erased until the
cassette tape is unloaded, or the
the camcorder set to
•For more details on how to operate the VCR, please
refer to its instruction manual.
•To stop programmed editing, press the
button, then stop the VC R.
[No. 3 ]
[No . 2]
.J
[No. 3]
button has been pressed, the
RUN
button to copy the
POWER
switch on
"OFF".
STOP
Erasing, changing programmed editing settings
To change a segment setting, first erase it, then
programme the new setting.
1
Rewind (or advance) the tape to the segment to
cancel, then start playback. The programme number
will start flashing.
2
Press the
CANCEL
number is flashing. The programme number will flash
rapidly for a few seconds then disappear. The settings
corresponding to that programme number are now
erased.
�Notes:
•When one segment setting is erased, its number will
stay available, if another segment is programmed, it
will be assigned the lowest available number .
•To erase all the settings, unload the cassette tape or
set the
POWER
About P. rogrammed editing and LANC
Connect the LANC cable only after the programmed
segments numbers are displayed on the TV. Connecting it
before may cause incorrect operation. Once the
programmed editing is completed, set the
on the camcorder to
"OFF",
cable.
During programmed editing with a LANC connection
make sure the remote control is not directed toward
the remote control sensor on the VCR.
24
button while the programme
switch to
"OFF".
POWER
then disconnect the LANC
switch
Advertisement
Table of Contents
