Table of Contents
Advertisement
USING THE REMOTE CONTROL
When using the auto pan/tilt head (model VA H-30, sold
separately}, you can control the recording angle from a
distance (using the supplied extension cable) while
watching the picture on the colour monitor.
Operating the auto pan/tilt head
1
Refer to the instructions supplied with the auto pan/tilt
head on how to install the camcorder.
2
Attach the extension cable to the colour monitor cable,
then plug it into the
REMOTE
camcorder.
3
Press the
MONITOR ON/OFF
monitor on, if necessary.
Turn on the auto pan/tilt head.
4
Direct the remote control at the auto pan/tilt head
remote control sensor window and operate as
described below.
A:
AUTO PAN
button ( Auto panning)
Press the
AUTO PAN
button for an automatic panning of
45° to the right and to the left. Press this button again to
stop the automatic panning. While in auto panning mode,
press the
button to set the desired height.
TILT
B:
TILT
button (tilting)
81: Press and hold the top part of the
an upward movement.
82: Press and hold the bottom part of the
for a downward movement.
A tilting of 1 Q° in both directions is possible.
C:
button (panning)
PAN
C1: Press and hold the right part of the
a movement toward the right.
C2: Press and hold the left part of the
a movement toward the left.
A panning of 45° in both directions is possible.
•Press the
TILT
and
PAN
movement at an angle.
Replacing the lithium battery
1
Open the stand (A) at the back of the remote control,
then open the battery cover
2 To
remove the battery, push it toward the front then
pull it up.
3
Insert the new battery with the
WARNING:
Please refer to the
WARNING
handling of the lithium battery.
terminal on the
button, to turn the colour
TILT
button for
TILT
button
button for
PAN
button for
PAN
buttons simultaneously for a
(B).
( +)
side upward.
on page 13 concerning the
20
AUTO PAN
A
TILT
B2
( B )
.
.
Advertisement
Table of Contents
