Omron SYSMAC C200HW-ZW3AT2-E-V2 Operation Manual page 85

L: Data Link
Comparing Data Link
Tables — V: Compare
1, 2, 3...
The processing will be performed in ascending order of node address.
To cancel the processing, press the F9 (Cancel) Key.
During the processing, "Wait" will be displayed in the lower part of the screen
and the progress of processing will be displayed for each node.
In write processing, each data link table will be simultaneously checked for
serious errors or link offset errors. If an error is detected in a data link table, a
window will be displayed to ask you to determine whether the data is to be
written to the node. Press "Y" to write the data or press "N" to cancel the write
processing, and then press the Enter Key. If "N" is pressed to cancel the
write processing, "Canceled due to table error" will be displayed at the node
address.
When processing for all the specified nodes is completed, "End" will be dis-
played at the lower part of the screen.
5. Then, press the F10 (End) Key.
"V: Compare" is used to compare data link tables in the computer memory with
data link tables set at each node.
1. Select "V: Compare" from the Transfer Data Link Table Menu. The following
window will be displayed to prompt you to specify the nodes for which data
link tables are to be compared with those in the memory.
Section 5-3
71