Omron SYSMAC C200HW-ZW3AT2-E-V2 Operation Manual page 28

Installation Procedure
14
When the installation program file is activated, the Controller Link Support
Software files will be copied from the floppy disk to the hard disk. Follow the
instructions displayed on the screen.
Note If the destination directory is omitted, the files will be copied to
C:\CLK.
5. When the installation processing is complete, the following message will be
displayed.
Add "path=%PATH%;C:\CLK" to AUTOEXEC.BAT.
Command Usage : CLKSS
6. Use a text editor to add the following line anywhere in the AUTOEXEC.BAT
file as indicated by the message in step 5.
path=%PATH%;C:\CLK
This completes the installation procedure.
Note If the Controller Link Support Software is registered in the SYSMAC Support
Software, it can be started from the SYSMAC Support Software's Option Menu.
See Appendix C Registering the Controller Link Support Software in the SYS-
MAC Support Software (page 163) for the registration procedure. We recom-
mend that the Controller Link Support Software be registered in this way if the
SYSMAC Support Software is already installed.
Section 2-2