Omron SYSMAC C200HW-ZW3AT2-E-V2 Operation Manual page 124

S: Display Node Status
1, 2, 3...
110
The following information is displayed.
Item
Data link (DataLnk)
Error message
(Error msg)
Communications
controller error
(Com controller err)
Backup status
Logging status
Setting information
(see note 1)
Note 1) Setting information is displayed only when the status of the following nodes
is read.
• Controller Link Unit for CS1-series PCs: CS1W-CLK21 (wired)
• Controller Link Unit for CS1-series PCs: CS1W-CLK11 (optical)
• Controller Link Unit for CS1-series PCs: CS1W-CLK12 (optical ring)
• Controller Link Support Board for IBM PC/AT or compatible computers:
3G8F5-CLK11-E (optical)
2) The "Display Node status" function can be used only for the Controller Link
Network. If networks other than Controller Link are specified, the node sta-
tus will not be displayed normally.
1. Select "S: Display Node status" from the Main Menu.
2. Specify the target node. Use the Cursor Keys to move the cursor to the de-
sired field, then enter a numeric value with Numeric Keys. (Use Alphanu-
meric Keys to enter a PC ID.)
Meaning
Displays the data link operation status.
Displays the setting error status.
Error: o
No error:–
Displays the error status of the communications controller of
the Controller Link Unit or Controller Link Support Board.
Error: o
No error:–
Displays the error information recorded in the Controller
Link Unit or Controller Link Support Board.
Error: o
No error:–
Displays the presence or absence of the error log in the
Controller Link Unit or Controller Link Support Board.
Error log exists: Y
No error log exists: N
Displays the terminating resistor setting status, baud rate
setting status, and external power supply status of the
Controller Link Unit or Controller Link Support Board.
Terminating resistor switch (for CS1W-CLK21-E only)
ON (with terminating resistor):ON
OFF (without terminating resistor): OFF
Baud rate (bps) (for CS1W-CLK21-E only)
2 Mbps: 2M
1 Mbps: 1M
500 kbps: 500K
Power supply status (for optical type only)
Power is supplied:
Power is not supplied:
Section
Y
N
5-10