Omron SYSMAC C200HW-ZW3AT2-E-V2 Operation Manual page 161

Error Messages
Error message
Send time-out
That name exists
Unable to start due to insufficient
memory capacity. Processing
stopped. Press any key.
Write protected
Wrong drive
Wrong file name
Wrong key
Wrong netwk number
Wrong network type
Wrong path
Wrong position
Wrong setting
Cause
A transmission wait timeout error has
occurred.
The same file name exists on the data
disk, memory card, or hard disk. English
characters are not case-sensitive (for
example, LAN and lan are recognized as
the same name).
The amount of free memory space is
insufficient.
The data disk is write-protected (the hole
in the corner of the disk is uncovered).
The specified drive name is incorrect.
The specified file name is incorrect.
The entered data is wrong.
An invalid key was pressed.
The number of networks specified in the
routing table is incorrect.
The specified network is not Controller
Link.
If the Controller Link Support Software is
running under Windows 95, there are too
many active applications running in the
background.
The specified path name is incorrect.
The data drive name specified in "Data
dsk drv" of the System Setup is
incorrect.
The cursor is in the wrong position.
The entered data is incorrect.
Appendix A
Action to be taken
Increase the maximum node response
time and execute again.
Specify another file name or save the file
on another data disk, memory card, or
hard disk (directory).
Check the amount of free memory space
and review the values set in FILES and
other parameters in CONFIG.SYS.
Always use the data disk in
write-enabled state (with the hole
covered).
Check the drive name of the data disk,
memory card, or hard disk.
Check the file name including the
extension, then specify the correct file
name.
Enter the correct data.
Press the correct key.
Specify the correct number of networks.
The specified network is not Controller
Link.
If the Controller Link Support Software is
running under Windows 95, there are too
many active applications in background
mode.
Check the path name of the data disk,
memory card, or hard disk.
Move the cursor to the correct position.
Enter the correct data.
147