Omron SYSMAC C200HW-ZW3AT2-E-V2 Operation Manual page 61

L: Data Link
Setting Data Link Tables
1, 2, 3...
1.
Area 1 of node 1
Link start word
Link word
Link word
Node model specified
in "Device Info set"
2.
The first word for each node is
automatically displayed.
Perform the following procedure to set a data link table on the Data Link Table
Screen.
1. Specify the link start words for areas 1 and 2.
2. Specify the address of the node from which to receive data.
3. Specify the number of words to be received ("Num Wd").
4. Repeat steps 2. and 3. for each node that is to participate in the data links.
Area 1 of node 2
3.
2.
No. of
Node 2
words
2.
3.
Node 3
No. of
words
1.
If the data link table for the remote node
has been set, the link source word will
be automatically displayed. If it has not
been set, nothing will be displayed. The
send area for the local node is
displayed as "Send area."
Note Items that can be input on the screen are displayed in green.
Node 2
Area 1 of node 3
Node 3
3.
Section
: Can be set
: Automatically displayed
If the data link table for the
node at the cursor position
has been set, the link source
word will be automatically
displayed. If it has not been
set, nothing will be displayed.
5-3
47