Advertisement
AM-1000
AM1000_manu
Bright signals of the Frontal
ALARM (Red) :
It is flashing kf at least a device is in alarm, and it has not been identified.
It is fixed lighted Acceso if all the alarm status have been identifed.
REMOTE ALARM (Red) :
It remains lighted if the output to the transmission devices for the fire alarm has been activated.
DELAY IN PROGRESS (Yellow) :
It remains lighted if the exclusion regarding the immediate outputs activation, has been operated,
used for type C outputs (sounder output) and type E (alarm trasnmission with dialer).
When this exclusion is activated (Escl\System Att.Imm.) the control panel, in case of alarm, delays
the outputs for the programmed time (Prog\Sist\Tem. Usc.All.)
During the delay time the led is flashing and it is possible to reset the delay using the "End Delay"
key, it i operats at the level 1.
ZONE/POINT MASK (Yellow) :
it remains lighted when there is almost an exclusion in the control panel. We are referig to all the
exclusions that could be done in the exclusion menù.
WALK TEST IN PROGESS (Yellow) :
Lighted when the test is in progress.
POWER OK (Green) :
Fix lighted when the control panel is powered
FAULTS (Yellow) :
It is flashing if there is almost a trouble, of any kind, that has not been identified yet.
It remains lighted if all the trouble have been identified.
SYSTEMS (Yellow) :
it is lighted if there is almost a trouble in the system (watch dog fall, mistake in the memory, and so
on)
MAINS (Yellow) :
it is lighted if there is a trouble on the feeder.
EARTH (Yellow) :
It is always lighted with positive condition or negative earth.
SOUNDER (Yellow) :
It is lighted if the sounder is excluded.
It is flashing when the sounder output is in trouble.
FAULTS TX (Yellow) :
It is lighted when the transmission output is excluded.
It is flashing when the output for the troubles transmission is in trouble.
ALARM TX (Yellow) :
It is lighted when the alarm transmission output is excluded.
It is flashing when the alarm transmission output is in trouble.
EXTINGUISHING (Yellow) :
It is lighted if the output to the extinguishing systems is excluded.
It is flashing when the command for extinguishing systems is in trouble.
Programming manual
Doc. M-145.2-AM1000-ENG Rev A.1
Page 3
NOTIFIER ITALIA
Advertisement
