Control Panel Adjustment [10] - Konica Minolta 7075 User Manual

Key Operator Mode

Control Panel Adjustment [10]

Use this feature to check the LCD touch screen and realign the position of the touch
sensor that may have shifted.
Key Operator Mode Screen
1 Press [ ] to display the Help Screen, then touch
HELP
Enter a 4-digit key operator password, then touch
Mode Screen. (See note.)
2 Touch
[10] Control panel adjustment
3 Touch the "+" indication at the upper right corner, then lower left corner on the
screen. The present coordinates will be displayed in the message area of the screen.
4 Check that the X coordinate and Y coordinate displayed in the first line of the
message area fall within the standard value displayed in the second line.
5 Touch the
CHECK BUTTON
check if the buzzer tone functions normally.
6 If the coordinates fall out of the range of the standard value in step 4, or the buzzer
tone does not sound in step 5, repeat the adjustment procedure from 3 to 5.
7 Press [0] of the control panel keypad to start writing the adjustment data.
If other key operator settings are required, press [1] to restore the Key Operator
Mode Screen.
8 If no further changes are required, touch
Screen to perform copying operations.
NOTE: If an invalid Key operator password is entered, continue by entering the valid 4-digit password.
Control Panel Adjustment Screen
to display the Control Panel Adjustment Screen.
s at the upper left and lower right corners on the screen to
PREVIOUS SCREEN
Key Operator Mode
to display the Key Operator
OK
to restore the Basic
Key Operator Mode 13-37
.