Selecting A Special Ratio For Non-Standard Paper - Konica Minolta 7075 User Manual

Basic Operations
Lens Mode (continued)

Selecting a Special Ratio for Non-Standard Paper

To determine reduction or enlargement ratios when using non-standard paper sizes,
refer to the Special Ratio Table on the previous page and follow the procedure below.
ORIGINAL-COPY WIDTH
FIRST, LOCATE THE ORIGINAL WIDTH ON THE HORIZONTAL AXIS.
THEN, LOCATE THE COPY WIDTH ON THE VERTICAL AXIS.
FIND THE RATIO ON THE TABLE WHERE THESE TWO VALUES MEET.
ORIGINAL-COPY LENGTH
FIRST, LOCATE THE ORIGINAL LENGTH ON THE HORIZONTAL AXIS.
THEN, LOCATE THE COPY LENGTH ON THE VERTICAL AXIS.
FIND THE RATIO ON THE TABLE WHERE THESE TWO VALUES MEET.
The ratio you use must fall within the available magnification range of 0.33~4.00. Use
the smaller ratio for reduction and use the larger ratio for enlargement.
Basic Screen with the popup menu for zoom setting
1 First, determine the correct ratio, as described above.
2 Touch on the Basic Screen to display the popup menu for setting the zoom
ZOOM
ratio.
3 Use the keypad on the popup menu to enter the desired reduction or enlargement
ratio in 3 digits; or use arrows to scroll to the desired ratio.
4 When the desired ratio is specified, touch
To cancel the setting, touch
5 Position original(s) FACE DOWN on the platen glass or FACE UP in the document
feeder, as required.
6 When all other setting are acceptable, press [
to complete the setting.
OK
again, select the desired ratio, then touch
ZOOM
START
].
Basic Operations 6-13
.
OK