Section 5-Cleaning & Maintenance; Cleaning External Parts; Cleaning The K-Cup ® Portion Pack Holder Assembly - Keurig B31 Owner's Manual

SeCtIon 5

cleaning External Parts

IMPORTANT: Make sure the Brewer is unplugged before cleaning.
Regular cleaning of the Brewer's external components is recommended.
Never immerse the Brewer in water or other liquids. The Brewer
1.
housing and other external components should be cleaned with a damp,
non-abrasive, lint-free cloth.
The Drip Tray and Drip Tray Plate should be periodically inspected and
2.
cleaned with a damp, non-abrasive, lint-free cloth. The Drip Tray and Drip
Tray Plate should not be put into the dishwasher. To remove the Drip Tray,
simply slide it toward you. Remember, when the red Drip Tray Overfill
Indicator appears, the Drip Tray is almost full. Carefully remove the Drip
Tray and discard its contents.
The Drip Tray has a snug fit to ensure it stays put in transit.
Cleaning & Maintenance
cleaning the K-cup
Holder assembly
The K-Cup Holder Assembly can be placed onto the
1. Cleaning the Parts —
top shelf of a dishwasher.
To remove the K-Cup Holder Assembly from the Brewer, lift
dishwasher.
the Brewer Handle to open. Grasp the top of the K-Cup Holder with one
hand. With the other hand, push up on the bottom of the K-Cup Holder
until it releases (fig. 1). After cleaning, align the K-Cup Holder with the
opening using the two front ribs as a guide, and snap into place from the
top (fig. 2).
1
fig.
12
Portion Pack
®
NOTE: Use low temperature cycles in the
2
fig.