Stihl TS 400 Manual page 8

STIHL TS 400
• Slide first deep groove ball bearing (1),
ring (2) and second deep groove ball
bearing (3) onto the shaft.
• Position the deep groove ball bearing
and press in with shaft until it rests
against circlip.
- Draw shaft out of deep groove ball
bearings.
- Insert second circlip in groove of
bearing.
Important! The seal of the ball bearing
must not be damaged.
• Place washer on bearing.
- Place bearing in rubber bearing from
the outside.
• Place washer on flange.
- Insert flange from the inside.
• Slide sleeve (1) and spring (2) onto
screw (3).
- Turn in and tighten screws.
• Slide on V-belt pulley with the longer,
machined-down collar first and secure
nut with 37.5 Nm.
• Fit thrust washer so that the groove is
located over the nose.
- Insert axial clamping ring.
8