Stihl TS 400 Manual page 7

STIHL TS 400
• Unscrew both screws (1) and
remove with helical springs (2) and
sleeves.
• Remove flange.
• Remove washer with rubber ring.
• Draw bearing out of rubber ring.
• Remove washer and rubber ring.
• Remove circlips from the
grooves in front of the deep
groove ball bearings.
Important! Use pliers with
shortened, rounded tips.
• Press both deep groove ball
bearings and the ring out of the
bearing with drift pin (1).
The parts are reassembled in
reverse order.
Note: Particular attention must be paid
to the following points.
• Insert circlip in one of the
grooves of the bearing.
7