Stihl TS 400 Manual page 26

STIHL TS 400
• Screw the threaded sleeve (1)
onto the screw thread (2) of the
crankshaft stub.
• Steady the spindle and turn the
assembly tool counterclockwise
until the drilled plate rests against
the housing.
• Draw the crankshaft as far as
possible into the deep groove
ball bearing by turning the
spindle clockwise.
- To remove the assembly tool,
unscrew the spindle counter-
clockwise and release the
assembly tool by turning it counter-
clockwise too (the crankshaft must
be steadied at the same time).
• Place a new housing gasket on
the sealing face of the clutch-side
half of the housing.
- Coat the cylindrical crankshaft
stub with oil.
• Insert the crankshaft stub in the
deep groove ball bearing.
• Screw M5x72 screws (from the
set of assembly tools ZS) into two
holes of the crankcase connection
to prevent the housing from twisting
and to guide the two halves of the
housing and the gaskets.
Note: The sleeves must engage in the
holes in the ignition-side half of the
housing.
- Fit assembly tool ZS as on the
ignition-side half of the housing.
• Draw the crankshaft as far as
possible into the deep groove
ball bearing by turning the
spindle clockwise.
26