Stihl TS 400 Manual page 51

STIHL TS 400
No. Designation
28 Torque wrench
29 Torque wrench
30 Screwdriver QI-T27x150
31 Crimping tool
32 Extractor
33 Insert, size 13
34 Insert, size 19
35 Insert, T 27x125
36 Drift pin
37 Assembly tool ZS (set)
38 - Threaded sleeve
39 Drift pin
40 Drift pin
Remarks:
1) DG screws may only be tightened with a torque wrench.
2) The version is equipped with an optical/acoustic signalling device.
3) May only be used to loosen DG screws.
Part No.
5910 890 0301
5910 890 0302
5910 890 0311
5910 890 0312
5910 890 2400
5910 890 8210
1116 893 0800
5910 893 5608
5910 893 5613
0812 542 2104
4116 893 7205
5910 007 2220
5910 893 2420
1118 893 7200
1119 893 7200
Use
Screw connections (0.5 to 18 Nm)
Screw connections (6 to 80 Nm)
For all IS screws
Attaching plugs to electrical leads
Extracting the flywheel
Nut for flywheel
Clutch
Tightening the IS screws
Driving the ball bearing into the V-belt
pulley
Removing the crankshaft
Installing the crankshaft
Fitting and removing the deep groove
ball bearing (clutch side)
Fitting and removing the deep groove
ball bearing (ignition side)
51
Rem
1)
2)
1)
2)
3)