Stihl TS 400 Manual page 49

STIHL TS 400
• Pull pick-up body off fuel hose.
• Lever out flange (1) of fuel hose.
• Pull out fuel hose.
- Prise tank vent out of spout.
• Pull out tank vent.
• Prise out spout.
- Unscrew filler cap.
• Disconnect chain holding cap.
The parts are reassembled in
reverse order.
Note:
The straight edge of the hose flange
must rest against the web of the tank
housing.
Insert manifold so that the straight
edge (1) points towards the
impulse hose (2).
Slide web (1) of holder (2) under the
housing. Press holder down until the
sloping edge (3) engages in slot (4).
Use a new gasket.
Tighten the screws in the two
housing halves with a torque of
7.5 Nm.
49